There’s not a huge fan club for the 1947 Chrylsers. They were huge cars weighing well over 3,000 lbs, 18ft long and room for the whole family. With names like Town & Country, New Yorker, Windsor, Saratoga – these car did demand respect.
1947 Town and Country – that sub-model name was used a lot by Chrysler
You’d think they’d have huge engines to push these around town but the engine line up for 1947 consisted of only 2, one 6 cylinder and one 8 cylinder.
The 6 cylinder was called the Royal/Windsor engine. It was an L head, cast iron hunk of metal. With a bore and stroke of 3.438 ” x 4.50 “, five main bearings, solid lifter it displaced 250.6 cubic inches. With the compression ratio at 6.6:1 (rather low) and topped with various carbs (B-B EV1 or Ev2 or E7L4 – for the fluid drive and B-BEx-1, EX3 or Ex2 for the manual shift) it managed to put out 114 HP’s.
Flat Head L6 Chrysler engine – powered some of these giants.
The 8 cylinder was labeled Saratoga/New Yorker. It was a flat headed iron blocked L8. The bore was smaller than the 6 cylinder @ 3.25″ and the stroke was slightly higher @ 4.875 (nearly 1/2 an inch higher), creating compression ratio of 6.7:1 and displacing 323.5 cid. It had solid lifters and five main bearings and took in air though a B-B E7A1 carb. This all produced horse power of about 135 @ 3400 RPMSs
1947 Chrysler Saratoga/New Yorker L8 engine
I really enjoy doing Engine Line Up series of blog post. Hopefully you do too!!!!
Thanks for reading.
Tim
Engine Line Up – 1949 Chevrolet
Engine Line Up – 1956 Hudson Part I
Engine Line UP – 1964-1966 Griffith
