Category Archives: Mustang II

Mustang II Diaries 3

By | | , , , ,
Leave a comment

http://mustangiidiaries.blogspot.com/

Trunk Before & After

My first major project was the trunk area. The weatherstripping as you can see from the picture (left) was dry rotted and peeling and I didn’t like how the backs of the tailights were exposed. I found out that standard coupes didn’t come with anything but a simple gray trunk carpet and a round piece of wood covering the spare tire. I wanted a cleaner look, so I purchased a plastic panel that came out of a 1978 Ghia to cover the taillight assemblies.
There was some rust around the trunk lid, so after removing the old weatherstrip (a nightmare!) I used rust treatment on the visible rust, and painted around the trunk lid and in the weatherstrip channel with white Rustoleum.
The next job was to install new weatherstripping, which I got from SSC Enterprises, but it did not go as planned. The weatherstrip dried all twisted in the corners and sticking out of the channel. I was so disappointed because I’d spent forever prepping and painting areas of the trunk and channel only to have the weatherstrip installation botched. I had to pull up the ruined weatherstrip, which thankfully did not cost a lot, but still, and scrape the adhesive off (again!) & repaint. Grr. Fortunately, around that time, I’d picked up a dremel tool with a wire brush and that made it a little easier than the first time.
After this setback I decided not to make a second attempt. Plus the next job would have been to replace the roof rail weatherstrip, which was supposed to be even trickier. So after ordering another package of trunk weatherstripping, I took the car to a body shop nearby and they did the trunk and roof rail for $95.
The last step was to find a jack assembly. The car’s original assembly was missing, so I bought a used one from another II owner and the jack assembly is now complete and correct. Plus I bought a new reproduction jack instructions decal and affixed it in the right spot next to the spare tire.
Here are the after shots:

Posted by Denice at 1:19 PM
Thanks for reading.
Tim

Ford Mustang Complete Brake Upgrade Installation

By | | , , , , , ,
Leave a comment

I’m seem to be on a Mustang kick lately.   Here is great video on upgrading the brakes on your late (relatively) Mustang.

Good luck.   Chase down the notes on MotorZ  site.    http://www.motorz.tv/

Thanks for reading.

Tim

Mustang Mechanic – TFI Swap 87-93 Mustang

By | | , , , ,
Leave a comment

These guys work on some newer ‘Stangs. But there are some good hints and tips for working on your Mustang.

http://mustang-mechanic.com

They have given permission for me to share the videos on Average Guy’s Car Restoration, Mods and Racing.

Thanks for reading.

Tim

Mustang II Diaries 2

By | | , , , , ,
Leave a comment

Engine Work–Part I

When I first got the car, it had to warm up forever or it would stall. At stop lights, I had to be careful to feather the gas pedal to keep it from quitting on me. I enjoy an occasional adrenaline rush, but not at every intersection!
Anyway, our first order of business was to get the car running better. This would end up taking a while as we troubleshooted/fixed/replaced/fiddled with different parts of the engine over several months.
First, we ordered a rebuilt carburetor and my dad and I installed it. With the new carb, the car ran strong on straightaways with no hesitation but ran rough at slow speeds. After that, we did a tune up, replacing the spark plugs and wires, distributor cap and rotor.
Next, I drove the car to my brother’s place and he adjusted the fuel/air mixture, fiddled with the vacuum advance tubing, and reconnected the kickdown rod. The hesitation was 99 percent gone after all that. When I drove home I got stuck in bumper-to-bumper traffic and the car never stalled or overheated. Yay!
The last piece of the puzzle was the fuel pump, which was going bad. As soon as we replaced that (only $30), the car ran better than ever. Now I can drive it without worrying about being stranded (although I do have roadside assistance through my insurance so I can get a tow home if that happens).
Update: Even though the car is more reliable and runs smoothly now, the engine leaks oil, and could use a reseal. I’m hoping to get this done in September/October 2010 (more on this later).

Posted by Denice at 11:22 AM

Labels:

Mustang II Diaries 1

By | | , , ,
3 Comments

http://mustangiidiaries.blogspot.com/

In November 2004, on a whim, I purchased a 1977 Mustang II off eBay. I don’t know the first thing about restoring old cars. But I had one of these when I was a teenager and it’s always owned a piece of my heart.There have been times when I’ve thought to myself–What were you thinking! I’m a mom of twin 6-year-old boys, with no extra money, and no mechanical experience! But I just love my car. Whenever I’m stressed, I drive it around town and I feel better.

Restoring my old Mustang–just keeping it running–hasn’t been easy. For a girl who never even
changed oil before, I had a LOT to learn. Progress is slow and I’m not quite ready to rebuild an engine, but I’m proud of what I’ve accomplished so far.

A Girl Gets In Over Her Head Restoring a 1977 Mustang II

Friday, July 2, 2010

New Wheels!

Pretty soon after getting my car, I decided to switch out the spoke-y hubcaps for some cooler looking wheels. Looking through an old Mustang II brochure, I saw a white with red stripe Cobra II with white lacy wheels and liked the look. Matching wheels to paint is not a look that appeals to everyone, but I thought that white wheels would be unique and add some personality to my otherwise ho-hum coupe.
I bought a set of 4 vintage white lacy spoke wheels from another II owner, along with four chrome center caps. As you can see from the pic, above, the wheels needed a lot of work. They’d been sitting in someone’s garage for years! I had them stripped down to the metal and powdercoated white. The picture below shows the powdercoated wheels and new tires mounted on the car. They look SO weird without the pinstripe! At this point I was thinking, hm, maybe this wasn’t such a great idea.
Locating someone to paint the pinstripes was more challenging than I thought. Apparently pinstripe painting by hand is a dying art. But I did eventually find a guy who owned a sign business (Shane’s Signs) in Manassas, VA who could do it. When I saw the final product I knew I had made the right decision about the wheels.
I might change them down the road but for now, I think they add a lot to the overall look of my coupe.