MOPAR’s 318 Part II

Before I start this next segment on the 318, I have to admit that organizing and presenting this work of art (oh..yeah..I’m laughing too!!!!) could have gone in a lot of directions.   The two that stuck out the most for me was by year (chronologically) or by brand.  Neither was a solid idea and at some point in the ’70s the only thing separating brands within most U.S. car manufacturers wasn’t much more than vinyl vs cloth seat covering.  So I decided to go with brands, Chrysler, Dodge and Plymouth, knowing that there we would be some crossover information and it might look a bit disjointed.  There’s some good stuff, and a couple of things you might know about the 318.

Chrysler began using the 318 in 1967 and carried that power plant until the late 1990s.

From 1967 to 1971 the 318 carried a 230 hp rating w/ the standard 2 barrel carb, managed 340 ft lb of torque and sported 9.2:1 compression ratio.  (that is actually a lower compression ratio than the original Ford 250 straight six I took out of my Mustang).  In 1967 the 318 engine was used in the Belvedere, Satellite, Fury, Coronet, Polara and Charger and in 1968 they added as the base option in the Dart GTS and Barracuda.

1967 Polara 4 door.

 

From 1972 to 1979 the 318 was bounced around in the horsepower arena between 150 to 140.  That’s nearly 100 hps lost from the late 1960’s.  At lower end of the new scale were the California models with the extra smog control.   It was still a mainstay, being the base engine choice for the Duster,  Cordoba, Monaco, New Port and unexpectedly the Road Runner,  just to name a few. It was never sported anything bigger than a 2 barrel carb and the compression dropped to 8.5.

It didn’t get any prettier in the 80s either, although there a bit of a bump in the high-end of the hp range to 175 hp but the company more than made up for that dropping the lowest number 120.  Interestingly, they made the California models with 155 hp and a 4 barrel carb.  The compression stayed about the same, but  in ’83 – ’90 they made a HD version of the engine that had between 165 to 175 hp, depending on the year and sported a 4 barrel carb.  This configuration managed to lay down 240 – 250 ft lb of torque, not too bad in one of the lighter cars, like the Dart, but barely power enough for the big old St. Regis. The 318 was also added to some of the most memorable cars….come on..you doesn’t remember “vooo..la rau….oh..oh…” (Volare )and the LeBaron, and Aspen.  Even some larger cars like the St. Regis, New Yorker, Gran Fury (I can’t see any car begin called grand with only 120 hp, but that’s just me.) and the Imperial.

1976 Volare

 

Oh and speaking of the Imperial something interesting happened in 1982 and 1983.  That little something was EFI.  More on that in the next segment.

Thanks for reading.

Tim

’89 318 efi intake to ’79 carbed 318 – Mopar Forums

Hello, my brother and I are thinking of taking on a project and would like to know if the throttle body injection components from the 1989 318 in his truck will work on a 1979 318 engine. The reasoning behind this is due to our …

Auto Factoid 8/8/2010

This isn’t my normal “on this date back in…” factoid.  This one is current.

8/6/2010

At the VW Automóveis Ltda. plant in Portugal today the hundred-thousandth third-generation Scirocco rolled off the production line. Since its launch in 1974, this compact sports coupe has been the most successful Volkswagen two-door with more than 800,000 sold to date. Another notable Giugiaro coupe is the breathtaking beautiful Alfa Romeo Giulia Sprint.

These cars were a hot item in the use for a short while.

2010 Scirocco

 Thanks for reading

Tim

Auto Factoids for the week of 7/11/2010

We got a first and a last on the same day – 60 years apart.

7/12/1922 – Frist Checker automobile  built

1922 Checker Cab

 

7/12/1982 – Last Checker automobile built

1982 Checker Cab

 

7/14/1955 – First Karman Ghia – I really like these cars.  I might own one some day, but maybe a Covair instead!!!

1955 Karmann Ghia - didn't change much from '55 - '74

7/16/1935…first parking meter in place in Oklahoma City, 30 minute later was the first parking ticket.

First Parking Meter

Thanks for reading

Tim

Auto Factoids for Week of 6/27/2010

HUGE this week…I mean HUGE…for me at least. 

6/30/1953  – Corvette debuts at NYC Motorama.  That’s a big deal.  6/30 is also my birthday.  Yup…5 years later to the very day the Corvette debuted my parents had another mouth to feed!!! 

1953 Motorama Corvette..And so it began!!!

 What?  You thought my baby pic…No Way!!! 

And 11 years later to the day the last Rambler was produced that was 6/30/1969. 

1969 - Rambler made a few fine cars...um...this wasn't one of them.

 

7/1/1908 United Motors was formed.  They build car components, at one point include Hyatt Roller Bearing Company (anti-friction roller bearings), New Departure Manufacturing Company (ball bearings), Remy Electric Company (electrical starting, lighting, and ignition equipment), Dayton Engineering Laboratories Company, later known as Delco Electronics Corporation (electrical equipment), and the Perlman Rim Corporation. It was later purchased by General Motors. 

Also on 7/1 the Graham auto plant in Canada produced its first Prosperity Six in 1931. 

1931 Graham

 

Again on the same day Pontiac selected Bunkie Knudson general Manager in 1956.  Bunkie Knudson – race car driver and innovator. 

Another biggie….7/2/1992 the 1 millionth Corvette was built.  It was a C4 Convertible.  Grabbed a picture of it at the National Corvette Museum while I was there a couple weeks back. 

1,000,000th Corvette at the NCM. Photo from my trip.

 

Thanks for reading. 

Tim

Wrenchin’ Tip – Priming a Holley 6/16/2010

YEAH!!!!  I know!! Where have these been…right?  Sorry, but I think I’m back on track. 

My Mustang has an old school 4 barrel Holley and although it starts pretty quick after a few pumps of pedal to get the mechanical fuel pump to push gas where it needs to be.  But if your old school muscle car or race rod sits for a while or you swap carbs often, you can spend some considerable time cranking on the engine.  This might seem like no biggie, but it can cause lobe failure on a flat-tappet cam. 

For my Holley there’s a better way.  

You need to locate your float-level sight plugs.  

Holley - image not from my mustang

 

A different configuration

 

Take a plastic squeeze bottle….  (Do you really need a pic of a squeeze bottle?)  Well just in case… 

Bottle Pic you don't need!!!

 

this type works the best…. and fill the float bowls with fuel until it trickles…(very little trickle…no fires…please.)  

Float Bowls

 

 This should be enough fuel to allow the fuel line to fill from the tank.  According to the specs a Holley can run 45- 60 seconds on full bowls. 

Keep your cam safe!!! 

Thanks for Reading 

Tim

Auto Factoids for the Week of 6/21/2010

Happy belated Father Day!! 

6/22/1954  Packard and Studebaker agreed to merge. 

6/22/1934  Hitler contracts Ferdinand Porsche to build cars with let to..you know  the VW and later the Porsche!!!!  

1934 VW

 

In 1958 on 6/26…just four days before I was born the first Datsuns was exported to the U.S. 

1958 Datsun.

 

We use to laugh at them.  My father and I once cut a wrecked B210 in half and replaced the entire rear and 1/2 of the roof from a donor car. 
That was kool!!!

The Art of Racing In the Rain

Ok.  I’m no Oprah but I just finished a book that race car people will love.  If  you love dogs, auto racing and a good story you are going to love reading  “The Art of Racing in the Rain”  By Garth Stein.

Go get it.  (no I don’t get paid for this…I just like it.)

Thanks for reading.

Tim

Auto Factoids for the Week of 6/13/2010

Oh..yes I’m behind. 

There was a huge one last week.. 

6/14/1832 – Nicolaus Otto was born in Germany…”Who?”   He invented the gas motor engine. An engineer and experimenter, Nicolaus Otto invented the first practical alternative to the steam engine in 1876 — the first four-stroke internal combustion engine. He called it the “Otto Cycle Engine,” and as soon as he had completed his engine, he built it into a motorcycle. 

The Otto Motor powered Cycle

6/16/1903 – The BIGGIE….Ford Motor Company was established. On the same day in 1953 Ford introduced the power steering.  (Two for the price of one) 

Also on 6/16/1896 Jean Peugeot was born in Paris.  Founder of Peugeot the auto maker.  The family began with coffee mills and bicycles and then cars. 

6/18/1943  Tom Gale was born in Michigan, Flint to be more exact.  His Dad was a designer for Buick and his grandfather worked the assembly for Buick.  Guess where he went to work when he finished school….nope….Chrysler.. Gale became head of design in 1985.  He previously worked on the some of the iconic cars such as the E-bodies-Barracuda and Challenger and was a major contributor to the  Chrysler Portofino concept car. 

1987-Chrysler-Portofinow Concept Car

 

6/19/1947 the Tucker shows up in Chicago. 

The Tucker-Torpedo - I love these cars!!!!

And on the same day, 1969 GM produced the 4 millionth Cadillac.   

This isn't actually "THE" 4 Millionth Caddy..but you get the idea.

Thanks for reading 

Tim

Hanging in Chi-town

Coming to you live from The Witt in downtown Chicago, it’s me typing on my laptop.   Three more days to enjoy relaxing and seeing the sights.

Speaking of sights..what I don’t see is a lot of muscle cars now or old…errrk… let me explain “lot” in this context it means…. “almost none”.  I’ve actual only seen one newish corvette (C6 – convertible) and a 1968 Mustang.  The Vette was on the street and the Mustang was parked in an alley.  That’s it!!!.

Muscle Car Drought..the only Vette I've seen!!

Ok…hang on,  if you think I just sit and type uninterrupted..nope…not much chance of that.

 My better half is here in the Windy City, at an international interior design event, where she’ll be giving a talk on….um…some interior design subject….um….yeah…I pretty sure that’s right and I tagged along. Nice little vacation where I can tool around a big city, which I enjoy doing from time to time.  What’s my point…umm…oh yeah….so I just ran out to get pick her up a couple of items while she is practicing her presentation.   On my return trip back to our hotel I spied  a beautiful custom 2010 Mustang..so..that makes three!!!

 Would you drive  your vintage or newish muscle car around a large city?  Let me say that I’ve been walking and taking cabs and even ridding on top of the double-decker tour bus and I’ve seen how these Windy City dwellers drive….I’d have to day…..I don’t think I would.  These folks drive 50 miles an hour between stop lights…but..still I might consider it early on a Sunday morning!!!

Oh…bTW…I know these guys!!!

My Parts Guy.

Oh and in the category of hanging 1930 Chevy’s….here ya go…a 4 door sedan at Portillo’s.

1930 Chevy..hanging in an eating establishment.

And up close:

1930 4 Door Sedan.

Engine and all are there for you to see.

Thanks reading.

Tim

New addition to the C4

It’s been a few days since I posted last, every once in a while life gets a little busy, business travel and a vacation.

However, this blog might have been idle but I wasn’t.

For as long as I’ve owned my vette, I’ve dragged around the original Bose stereo.  Yup, 1980’s technology, with a cassette  and AM and FM radio.  (You kids won’t remmmbbberr….hang on while I put my teeth back in…there…better…remember these and I use to walk to school when I was a kid, up hill both ways and snow up to here!!!!) It sounded really bad.  The cones were mostly dried out from the AZ heat and I think I’ve spent enough on original used speaker and amps (each speaker had its own amp) to buy four stereos with big amps and have the vette vibrate down the street without starting it.  I just didn’t want to get read of the thing….because it was original equipment.

Well, I finally broke down and replaced it.  HOWEVER, not with just a cd player and radio.  Nope.  I wanted something a little more fitting for the car. 

The 1984 C4, as more Corvette peeps know, was the most technologically, advanced car at the time.  It was the first car with computer controlled fuel injection, electronic shifting, and a dash-board with digital and graphic displays….and you can switch it from English to Metric.  So I wanted a stereo, befitting the other technology, but…..say it with me….Average Guy with and Average Budget!!!!!

So I couldn’t go to crazy.  What I did find was an all digital Pioneer Media Center.  No CD.  USB connection for IPODs or just a thump drive.  HD Radio that finds adds all the radio stations and …..wait for it…..drum roll………blue tooth phone connections.  KOOL or what…my wifes’ 08 Lexus has got nothing on my 84 Vette now…..ok..well she does have air-conditioned seats and navigation (…but my phone has that)  and the rear camera and a back seat (over rated!!!) and moon room (but my roof comes off!!)…away there’s more.

I did not want any thing to happen to the original speaker covers nor did I want any new holes, I wanted great sound and an original look.  So I added Alpine SPS 699’s in the rear, 260 watts and 85 RM and Alpine SPS 400 for the door speakers, 140 watts peak and 45 RM.  She sounds great.

 The original Bose system is safe,  all packed and stored.

Thanks for reading.  Drop me a note.

Tim