With the likes of Industry Legends like Bruce Meyers, Speed demon Don Garlits, incredible machines since its inception in the early 1900’s, manic machines like the 270+mph 288 GT0, the Bonneville Salt Flats is the mecca for nature/car enthusiasts with an incredible backdrop showcasing the fastest pieces of metal on wheels in the world once a year in quiet Wendover, Utah.
The Alfa Romeo 33 Stradale is an extremely rare and cool road car built by Alfa Romeo. Only 18 are reported to have been made, plus three design studies based on the 33 Stradale the 33.2, Iguana and Carabo.
The race-bred engine bore no relation to the mass-produced units in Alfa’s more mainstream vehicles. Race engineer Carlo Chiti designed an oversquare (78 mm bore x 52,2 mm stroke) dry-sump lubricated 1,995 cc (121.7 cu in) V8 that featured SPICA fuel injection, four ignition coils and 16 spark plugs. The engine used four chain-driven camshafts to operate the valve train and had a rev-limit of 10000 rpm. The engine produced 230 bhp (172 kW) at 8800 rpm in road trim and 270 bhp (200 kW) in race trim.
And speaking of that composite bodywork, it is a gorgeously Italian (designed by Alfa Romeo and assembled by Maserati in Modena, no less) exotic design that Alfa says was inspired by the famed Alfa Romeo 33 Stradale racing car penned by Franco …
The 2015 Chevrolet Corvette Z06 posts some impressive performance numbers thanks to its 650-hp, 6.2-liter supercharged V-8. It also posts some impressive BTUs. A byproduct of that flame-breathing engine is heat, and lots of it, generated primarily by combustion, friction, and intake-air compression. These and other factors, such as the low hoodline and pinched frontal openings demanded by stylists and aero engineers, contribute to the complex thermal-management task faced by engineers working on nearly all of this car’s varied subsystems. To assure that the Z06’s maximum performance is attended by minimal risk of failure, GM performed heat-related stress analysis and modeling, as well as conventional hot-weather testing in Arizona. Here’s a look at the maximum operating temperatures of Z06 components:
These are some extreme temp and they will be higher during an Arizona summer
With an MSRP of about $79,000, but with trim levels that’ll take up much closer to $100K, the 2015 Z06 doesn’t mess around with measly six cylinder engines that pretend to be powerful with aid of umpteen turbochargers. It offers a massive, supercharged …
Racing Tires for the Street: Michelin engineered two tire options for the 2015 Z06. The standard Pilot Super Sport ZPs are sized 285/30ZR19 in front and 335/25ZR20 in back. A Z06 with the Z07 performance option gets Pilot Sport Cup 2 ZP tires in the …
Got a few huge debuts this week’s Auto Factoids (#AutoFactoids), so lets get started.
Feb 23, 1954 – Ford shows off the Thunderbird for the first time.
Although the Thunderbird wasn’t available until 1955 it was in design. Originally it was going to be called the Vega!!
1955 T-Bird
Feb 23, 1967 – Pontiac debuts the Firebird
The brain child of John Delorean the Firebird started out as the Banshee in two versions (XP 833 convertible or Hard top coupe). 1966 it was a two seater referred to as XP-798.
Look some what familar? Corvette maybe?
Pontiac brass thought so too and these concepts were not approved.
The XP 798 Firebird concept.
1967 Firebird
Feb 24, 1968 – American Motors debuts the AMX
1969 Hurst version…NICE!!!
Feb 25, 1905 – Jose Piquero crossed the Andes in a Caddy!!
Had to dig for this one. Found it on http://forums.cadillaclasalleclub.org. Back in 1905 a Cadillac was the first car to cross the Andes (the mountain range not Andes, New York) that happened on Feb 25th, but I don’t know why, nor does anyone else seem to know. I can tell you the Andes are in South American and average about 14,000 feet in altitude. The ’05 (that’s 1905 not 2005) Caddy was, well, let’s say “airy”. That ‘brave’ (pronounced ‘Crazy’) soul was Jose Piquero. But wait, some sources say it wasn’t a Caddy at all, but a Oldsmobile.
So I would imagine in either ride the trip was a tad bit chilly.
1905 Olds
1905 Caddy
Feb 27, 1934 – Ralph “Corvair Killer” Nader was born in Conn.
You can celebrate that (anyone? Bueller, Bueller…) if you absolutely can’t find another reason to have an adult beverage. I wonder if he fell out of a car seat when he was young?
1962 Lakewood
The last Corvair Vert.
I’m seeing the Corvair but can’t help notice the Nova’s on the rail car.
Feb 28, 1940 – Mario Andretti born in Montona, Italy
As I’ve said before, I’d love the chance to hangout in car culture in Australia for couple months….maybe one day. But it’s true you just don’t find a lot on the net. Read on and chase the link for more.
Trying to find any substantial information about Australian Pro Stock racing on the Internet is like trying to get your kid to eat Brussels sprouts – simply speaking, it’s tough! Seeing the video of this Aussie Pro Stock 400ci SBC engine from Patterson Racing singing on their dyno takes your author’s mind back to the small-block Pro Stock Truck class and their high revving 358 inch engines that departed NHRA competition just over a decade ago.
Patterson Racing has been in business for 35 years and is widely known for their cutting edge engines and innovations in the racing arena. Naturally aspirated small blocks like the ones used in the Australian National Drag Racing Association‘s Pro Stock field are close to their heart. The typical engine puts out over 2.75 horsepower per cubic inch without any power adders and they spin at over 10,500 rpms. When compared to the NHRA Pro Stock engine of the 500-inch variety the little ANDRA version is not as tightly regulated in terms of rule restrictions on modification.
The teams, the drivers, the fans, the circuits… few, if any, were satisfied with how Formula One has shaped up since the current regulations took hold last year. But that doesn’t mean they aren’t working on it.
1000 HP F1
At a recent meeting of the F1 Strategy Group, the leading parties in the sport outlined a new framework that would radically shake up the cars themselves while keeping costs in check. And the biggest change could see the engines producing around 1,000 horsepower.
Q: Then let’s put it this way: you had zero impact in F1 racing for some time because you haven’t been in F1 racing… PS: True. And now I am enjoying being with Williams. It is a great team. Yes, of course it’s nice when you are in demand – but to be …
Ferrari’s strong form in the first pre-season Formula 1 test has left rivals wary that it might have made a much bigger leap than expected over the winter. Sebastian Vettel and Kimi Raikkonen were fastest on three of the four days of the first pre …
BMW is retiring its hugely successful, V8-engine Z4 GT3 racer later on this year. It’s replacement, the BMW M6 GT3, was spotting undergoing testing this week.
And, good grief, does it look mean. The Z4 is one of the most cartoonishly pumped-up cars on the GT3 and the M6 carries on the tradition. The wheel arches are gigantic, the sills are like shelves and the rear wing would make a decent bar.
Power comes from the twin-turbo, 4.4-litre V8 found in the road-going M6. Though modified to cope with the demands of racing, it will probably produce less power than the road car, thanks to the Balance of Performance system that equalizes the extremely diverse GT3 field.
BMW is set to phase out its Z4-based race car from GT competition at the end of this year and replace it in 2016 with a new car based on the M6 platform. The new race car is being developed to GT3 specifications, with versions likely developed for the …
For anyone that’s thinking BMW has lost its way with cars like the oddly-shaped Gran Turismos and the blasphemous front-driving 2-Series Active Tourer, this promo video for the 2016 M6 range should restore your faith in the blue and white roundel. The …
… new information about the car. Enquiries from North America are to be sent by E-mail to M6GT3NA@bmw-motorsport.com. Featured GalleryBMW M6 GT3. News Source: BMW, BMW Blog · BMW Coupe Racing 2016 bmw m6 gt3 bmw bmw m6 bmw m6 gt3 …
As we run through the middle of the 2nd month of the year, here are your Auto Factoids (#AutoFactoids). A light week this week.
Feb 10, 1942 – Pontiac stops car production for WWII
– As you know WWII took a lot of sacrifice on many countries and their citizen and even corporations. A lot of resources were used in producing automobiles, in particular metals that could be used to produce planes and Liberty ships and ammo. That is why the U.S. government asked the car industry to halt production and assist in producing just about anything to support the war effort. Pontiac was one of the last to comply with the request. Pontiac’s main contribution? It was the 20-mm Oerlikon anti-aircraft cannons. Check out what they could do!!!
Feb 11, 1932 – Ford announces new V8 engine
The Model A was history and the Model 18 ruled – with Ford’s new FlatHead V8 in 1932 (also referred to as the Ford Flathead or Flathead Ford or just Flatty). It lived on in the Model 40 in 1933 and 1934. It continued on the 1950’s.
1932 Flatty
Feb 12, 1908 – Start of the New York to Paris car race.
– The race route was from NYC, Albany, Chicago, San Francisco, Seattle, Valdez Alaska, Japan, Vladivostok, Omsk, Moscow, St. Petersburg, Berlin and finally Paris. It was sponsored by the New York Times and the LA MATIN (Paris news paper) and finished 169 days later.
Oczywiście, trójkołowe motocykle są świetnym rozwiązaniem dla wszystkich tych, którzy z jakiś powodów nie posiadają już pełnej swojej sprawności i nie mogą jeździć konwencjonalnym motocyklem. Skoro to stwierdzenie mamy z głowy, to co musi wydarzyć …
“The East Coast rod is a blood relation of the sports car,” the chairman said, “while the West Coast rod has the style of the dry-lakes roadster, of Bonneville and the whole Ford ‘flathead’ V8 scene, probably what most people envision when they hear …
Jay’s latest adventure takes a deep dive into hot-rodding history with this beautiful 1932 Ford Highboy roadster . But don’t pass this off as just another deuce coupe . No, this car is the deuce coupe. Jay has with him Bruce Meyer, the car’s restorer …
The old drag strips are disappearing. I have an article coming out about an abandon drag strip right in my backyard.
Terminal Island in the Port of Los Angeles didn’t play by the typical drag strip operations manual. Intermodal shipping containers surrounded the strip and served as the basis for some of its structures. It had no national drag racing organization affiliation, and everybody pretty much run what they brung. It opened and closed nearly a dozen times over the course of three decades, and now, in the midst of an LAPD crackdown on street racing in the city, fans of the drag strip are working to bring it back.
“Our main goal is to keep everybody off the streets,” said Donald Galaz, a lieutenant with the International Brotherhood of Street Racers and the founder of Project Street Legal, an initiative to return racing to Terminal Island. “But you know the way politics is – the wheels go very very slowly.”
I remember my first drag strip experience, it was in the middle of a corn field in the middle of Texas (just outside of San Angelo). I recall thinking how awesome it was to have a place to test your skills – legally!! I wonder if it’s still there?
Two men were charged late Friday with drag racing on East Andrew Johnson Highway, Greeneville police Officer Joe Prokop said in a report. Charged were Justin E. Aiken, 21, of 127 Sam Aiken Road; and Kieffer L. Keller, 20, of 1500 John Graham Road.
LOUISVILLE, Ky. — The dragster is all black, and its driver is dressed in all black, too, from the top of the helmet right on down to the shoes. For a long time, no name was displayed on the sides like there are on other machines. It goes to the line …
Here is the line up of Auto Factoids for the first week in December!!!
Nov 30 1960 De Soto ceases production. The last De Soto produced were really the Chrysler Windsor, most did not sale, even though dealerships continued to received cars after the brand was terminated.
1961 Windsor
1961 DeSoto
Way before that on Nov 30, 1900 Germany patented an automobile front wheel drive. Although this is a common historic fact, there is some evidence that the first production car with front wheel drive was a French car. There exists a French Patent around 1898 or 1899. The manufacturer was Société Parisienne and the car was the Victoria Combination.
It was a lightweight two-seater trailer,known as a ‘Victoria’, combined with the back axle and mechanical components of a motor tricycle, but this axle was placed in front of the trailer and steered by a long tiller on which the controls were located. The first examples were powered by 1.75 or 2.5 horsepower De Dion Bouton engines geared directly to the differential, but larger engines of this make were fitted as they became available.
1900 Victoria Combination
December 1, 1925 GM purchased Vauxhall. Vauxhall started out as engine manufacturer mainly for pumps and marine use (1857 – Alex Wilson). They began making cars in 1903. Here is a video of a 1903 Vauxhall. They are still producing cars using the Opel name under GM.
One more of it on a road test.
Back 1913 (just over 100 years ago) on Dec 1, Ford fired up the first continuous assembly line.
Ford’s Production Line
And just one day and 14 years later (Dec 2, 1927) Ford began selling Models A off this assembly line.
1927 Model A
Dec 3, 1951 is Rick Mears birthday – one of only three drivers to win the Indianapolis 500 3 times.
Rick Mears in his Formula 1 car
That round out the week. Thanks for reading Auto Factoids.
Tim
If you’d like to sponsor a week of Auto Factoids contact me directly.
[ ATTRIBUTE: Please check: http://www.flickr.com/photos/87806373@N04/8118612139 to find out how to attribute this image ]
