Welcome back to the final few posts of the floor pan replacement for #ProjectSportsRoof.
Let’s get right down to it.
I realized that I didn’t catch much of the work on the floor plan under the right rear seat. That was really a lot of work. They don’t make a panel for that on the 1973 Mustang SportsRoof. So I had to use a foot well panel and “customize” it to fit. See here:
This shot is that pre-welding and it shows the hole above the muffler, under the seat. (Sorry for the short clip)
This image shows the customized foot well floor panel:
A lot of work went into forming that panel.
Yes it was tough to make it, there were a lot of cuts. (The tub there is Irish Spring soap – it keeps pack rats out of the Mustang while it’s parked!)
If you recall the left side of the car wasn’t bad at all and I replaced just the foot well panel. It cut the same as the right side and here it is in place. Here’s a little recap of the work done.
Next up is the welding, coating and heat/sound barrier.
Thanks for reading.
Tim
#ProjectSportsRoof
