A quick recap, I had a 1967 Ford Mustang Shelby manual 4 speed transmission rebuilt and installed it in my 1970 coupe. This included a Hurst Competition Plus Shift Kit. Of course the configuration isn’t even close to the original 3 speed and the old bracket for the reverse light switch won’t go back on.
I didn’t really think of this as the time of the installation so I just zip-tied the wiring and old switch up until I picked up the conversion part for the Hurst kit. This included a reverse light switch and a properly formed bracket. Cost was about $29.00 at the same local hot rod shop I bought the shift kit from – they are car guys not salesmen, which is why they didn’t mention the light switch bracket.
Don’t asks me why I felt the need to take video of the kit still in the package but here it is:
As you can see in the video below. The switch had two screws as posts for the wiring, new switch..old school technology. Basically you’d wrap the end of a wire around the screw and tighten, not a great connection for hanging under a car, nor for the amount of vibration the 302 dishes out. Used the screws and the small ‘lock” washer to hold the electrical connectors in place. That will last.
I’ll up this piece tomorrow.
Thanks for reading.
Tim
Very cool! Looking forward to part 2.
Try to get it posted later today Thanks for reading.