Steeda unveils full line of Ford Mustang Boss 302 parts

Whether you’ve seen a Ford Mustang Boss 302 in shambles, one tearing up the track, or perhaps another upon the showroom floor–it doesn’t matter.  Bottom line is, we’ re pretty sure anyone with a blue-blooded pulse wants one.  So, if you are one of the lucky ones to get your paws upon the steering wheel consistently, then you might want to listen up.  Steeda Autosports now has a complete line of aftermarket parts to amp up the already awesome 2012 Boss 302 in order to tweak the suspension, intake, and some additional custom tuning to make every droplet of atomized fuel count.

So just what all’s in store?  Keep reading to get the rest of the story via Steeda & be sure to check out their site loaded with offerings!

Steeda News Release

Steeda Offers a Full Line of Boss 302 Performance Products

The new Ford Mustang Boss 302 is viewed by many as the best overall Mustang Ford has ever produced. As good as it is in original form Steeda has found ways to improve it and take it to the next level.

Starting with the suspension, the Steeda Boss springs are designed to slightly lower the vehicle in the front and lower the rear approximately 3/4”. With the front height remaining largely unchanged, the front roll center geometry remains optimal. However, by substantially increasing spring rates, body roll is reduced as is nose diving during heavy braking. Thanks to our years of experience with Mustangs, we are able to do this and still maintain near stock ride quality characteristics.

2012 Boss 302 Laguna Seca

We have also designed several levels of suspension packages that include our awesome Boss springs, adjustable front and rear swaybars , adjustable upper strut mounts and more to achieve the maximum handling potential of the Boss 302 Mustang.With the new Boss 302 Mustang comes the new Boss 302 engine. We took our years of experience building performance proven cold air induction kits and designed a kit tailor made for this heavy breathing new engine. Starting with a high flow filter we added our “race tested” velocity stack” entry, this is located within a stainless steel heat shield with a rubber gasket to seal it against the hood. We also retain the factory cold air feed duct from the front bumper. We then added a 101mm MAF housing which is coupled to a new high flow inlet tube with our Cool-Tube technology. All of this adds up to 30 plus horsepower when combined with the required custom tune that compensates for the increased airflow.

So, if you are looking to get the most out of your Boss 302 Mustang, look no further than Steeda Autosports!

Source: Steeda