Mustang Upholstery Part V

I thought I’d take a minute finish up the write-up on the very first upholstery job.  I finished it up a two weeks ago and really missed driving the Mustang, but that’s what happens when you do your own work and you can only fit it between all the normal life stuff that needs to get done.

Yes, as I  was reminded twice by a couple of car acquaintances, I used a kit, some say they aren’t much different from slip covers, but as you can see in my shots here that’s a bit of an understatement.

Now these next two videos are not all that great but I think you can see the removal of the back and the fasteners.  I’ve worked with these type of fasteners before in my father’s body shop (back in the early ’70s) nearly all door panels and seat back were fastened in that way.  They work really well but bend them (and they do bend easy of they aren’t aligned with the hole and pressure is applied) and you’ll have to spend sometime reshaping them, even then they might not hold properly, or replace them.

Check out the videos:

 

 

 

Here are a few more photos and the finished product.  Not to bad for my first one.  I have the passenger’s side to do.

Helpful hint:  All the hardware and fasteners have to pass through upholstery.  Rather than  try to cut holes, I made X cuts and pressed the screw or hardware through.  This made it as tight as possible.

Here you would pass the hog wire while in the hog-nose pliers through the cloth between the upholstery and the wire.  You then have to shove this down between the two pieces of foam and grab a spring.

Replacing the seat track was done before I married the bottom and back.  Placing it back in the car was a little tricky..until I figured out that moving the set on the track was the way to get the studs to drop back in to holes in the floor board.

Over all this was not as tough as I thought it would be.  The passenger side will be quicker.  I’ll post the final product on that side.

Thanks for reading.

Tim